Slicer Discord
Base clamp for Apple iMac – Modèle 3D imprimable de Thingiverse Thingiverse

Base clamp for Apple iMac

par rh700
18 Téléchargements
9 Likes
1 Makes
Voir le modèle
This is a basic clamp for securing the iMac base to a table. It requires two 1/4-inch screws that go into/through the table but nothing goes through the iMac base itself. It should be printed "upside down" so that you get a smooth top and a taper underneath to match the taper of the iMac base. The side walls are angled to keep the base from sliding backward and there is a hook on the front to keep the base from sliding forward. The screws are very close to the base so they do most of the holding and you don't rely too much on the strength of the plastic.
Source
Thingiverse
Ce qu'il faut pour imprimer: Intermédiaire Confiance faible
Pourquoi ?
post-traitement important
Monobloc Visserie requise
Supports 1/3
Assemblage 0/3
Réglages 1/3
Taille du plateau 0/3
Post-traitement 2/3
Imprimante
FDM / FFF
Format de fichier
STL
Matériau
PLA
Post-traitement
Ponçage, Visserie
Logiciel
Cura, PrusaSlicer ou similaire
Pas encore d'évaluations
Pas encore de commentaires – soyez le premier !
Feed Blog Slicer Calculateur Recherche par image Soumettre Contact Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Ajouter à la collection