Base for "Octo-Type" Helping hands

8/19/15: Updated with Tool-Holder files:

- Butterfly needle/syringe holder
- Dino-Camera holder
- Generic flat sided tool holder
- Flat top tool posts
- Splash screen holder
---------------------------------
This is a project using parts from an old lamp. There's an image of the Donor-lamp in the list above. The lamp had a few "goose necks" and cost about 10$ on sale, at a big box. The idea was to use these goose-necks to hold tools on a work surface.

First, remove the light fixtures and pull out the wires. Take off the stand. All that remains is the goose-necks and the metal ring where they are all attached.

Second, make a small platform from scrap wood or drill a hole in your desk. You'll need a 3/8" bolt with two washers and a nut.

Next, 3D print the "helpingHands.stl" file, then attach the goose-neck base to the 3D printed support (or workbench).

Finally, start developing your own set of custom tool holders for the ends of the goose-necks. Maybe a c