Slicer Discord
Base for TinyTapeout 06+ Demoboard – 3D-Druckmodell von MakerWorld MakerWorld
Electronics

Base for TinyTapeout 06+ Demoboard

2 Downloads
2 Likes
1 Makes
Zum Modell
This is a base or skeleton case, that protects the underside of the PCB, mostly from unintended shorts do to accidentally placing the board on top of conductive elements on your workbench. There is space inside for all the through hole connectors (also the ones that are not populated initially), and the stock rubber feet will also fit, so you don't have to modify the board in anyway. It does get raised up a little higher from the table, so you might need similar support under attached PMODs with large connectors or other things connected, to not put stress on the headers. The base comes in two variants:One that is designed for M2 brass insertsOne for using M3 screws directly into the printed hole.Except for the hole size, the two are identical. OpenSCAD design is included, if you want to tweak or modify and built on the design. This can also be done using the Customizer. I also added small rubber feet on the bottom, so that it more or less stays put when testing and moving attached
Kategorie
Electronics
Quelle
MakerWorld
Veröffentlicht
Aktualisiert
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Einteilig Hardware nötig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA, Polycarbonate
Nachbearbeitung
Hardware
Software
Cura, PrusaSlicer o. Ä.
Gleicher Designer, mehr Plattformen

flummer veröffentlicht auch auf

48 zusätzliche Modelle auf 2 weiteren Plattformen

Verifiziert durch übereinstimmende Modelltitel über Plattformen hinweg.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen