Base for Tom and Jerry

Base for the characters of "Tom and Jerry" cartoon series created by Hanna and Barbera for MGM. The series features comic fights between an iconic set of adversaries, a house cat (Tom) and a mouse (Jerry). The plots of each short usually center on Tom's numerous attempts to capture Jerry and the mayhem and destruction that follows. No supports are required. If you have the proper filament colors, no painting is needed. The assembled base is 105mm tall. ---------------------------------------------------------------- The full Tom model: https://www.printables.com/model/518371-tom-cat The full Jerry model: https://www.printables.com/model/536749-jerry-mouse --------------------------------------------------------------- Enjoy! ........................................................................................................... Special shoutout to maker Benoît Lussier for providing QA printing and quality feedback. ........................................................................................................... **Print Instructions:** Supports: No Resolution: .2mm Infill: 15% *************** For all my models: Do not enable 'Detect bridging perimeters'. This is a parameter that PrusaSlicer 2.6 enables by default. Do not enable 'thick bridges' Do not set 'arachne' for perimeter generation. PrusaSlice selects this option this by default Do not enable 'detect thin walls'.  *************** Refer to the notes below for a few helpful printing and assembly instructions. ...........................................................................................................   **Building the model** Colors Black: (Paramount3D PLA - Black) base_wall (see notes for layer change colors) base_hole .. Red: (Hatchbox PLA - True Red) base_wall (see notes for layer change colors) .. Wall color: (Devil Designs PLA - Vanilla) base_wall (see notes for layer change colors) .. White: (Overture PLA - White) base_moulding_right base_moulding_left .. Floor: (PolyTerra PLA -