Thingiverse
Baseball Bat Hanger
by xaninator
7
Downloads
11
Likes
0
Makes
After some tips from reddit/r/functionalprint I have a second version (v2 in the files). Still haven't tried printing it, waiting for some more filament, so I'm not sure if it is even strong enough yet.
Not sure if the screen captures show the optimal print orientation, but they will need support. Sorry for the upside down V2 .stl.
V1 was designed to go over a coat hanger while V2 was designed to go over the rod itself. V1 would likely slide down the hanger if it wasn't perfectly balanced.
V2 is thicker everywhere and I tried to get a lot more support on high torque areas and therefore Cura says it will need 53g of PLA at 20% grid infill.
Not sure if the screen captures show the optimal print orientation, but they will need support. Sorry for the upside down V2 .stl.
V1 was designed to go over a coat hanger while V2 was designed to go over the rod itself. V1 would likely slide down the hanger if it wasn't perfectly balanced.
V2 is thicker everywhere and I tried to get a lot more support on high torque areas and therefore Cura says it will need 53g of PLA at 20% grid infill.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!