Thingiverse
Electronics
Model downloaden
Basic 3.5" Raspberry Pi LCD Bezel & Back Plate
63
Downloads
54
Likes
0
Makes
I made this Basic 3.5" Raspberry Pi LCD Bezel to be stand alone protection for the LCD while testing around the bench. Mainly not having to plug it into the Pi directly, but instead using a cable. This will not mount on a Raspberry Pi with the back cover on FYI, but does somewhat fit with out it.
I used some sticky felt pads on the back of the LCD to make the cover fit snugly since the chips on the LCD are raised up. I got the felt pads from Walmart near the hardware section.
The screws are M3 x 5mm or less, or use what ever you have on hand that will thread into it.
In the future I may design a new back plate to allow mounting to vesa style mounts and the like.
I used some sticky felt pads on the back of the LCD to make the cover fit snugly since the chips on the LCD are raised up. I got the felt pads from Walmart near the hardware section.
The screws are M3 x 5mm or less, or use what ever you have on hand that will thread into it.
In the future I may design a new back plate to allow mounting to vesa style mounts and the like.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
