Slicer Discord
Basic Aircraft Grips (Vans RV) – 3D-printbaar model van MakerWorld MakerWorld
Vehicles

Basic Aircraft Grips (Vans RV)

2 Downloads
1 Likes
1 Makes
Model downloaden
I was sick of the ray-allen foam grips in my aircraft. I have smaller hands so I wanted something a bit slimmer. My RV9a has different diameter control sticks for pilot (1") and passenger (7/8") and my sticks are a bit longer so I wanted a longer grip that would allow me to rest my hand in different locations for control. My setup is basic with a single PTT in the top. These are configured for a slightly less than 12mm (11.6mm) momentary push button I purchased off of amazon. I'm excited to get them installed in the plane and test them out.
Categorie
Vehicles
Bron
MakerWorld
Gepubliceerd
Bijgewerkt
Wat je nodig hebt om te printen: Beginner Lage betrouwbaarheid
Eendelig
Supports 1/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 0/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
PLA
Software
Cura, PrusaSlicer of vergelijkbaar
Nog geen beoordelingen
Nog geen reacties – wees de eerste!

Vergelijkbare modellen

6 Suggesties
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie