Basic Airsoft Supressor (ACETECH Brighter C Housing)

A very basic suppressor for airsoft, meant to house a ACETECH Brighter C tracer unit

take off the 3 small screws off the back cover of the tracer unit,
slide the unit in the suppressor body and line up the screw holes and screw it back on,
store the back cover somewhere safe so you don't lose it

I prefer the smaller 100mm model for pistols and created the 150mm model for rifles,
if you want a longer/thicker model - feel free to leave a comment!

THIS SUPRESSOR WILL NOT ATTACH TO BARREL WITHOUT A TRACER UNIT AS IT IS ONLY A HOUSING

Instructions:
1. Body should print fine as is
2. You should rotate the cap upside down so the large end is flat on the surface
3. I print with 0.2 layer height and brim
4. the cap should friction fit into the top of the body and rest on the cap of the tracer unit
using the tracer unit's front cap geometry to keep itself aligned