Thingiverse
Basic Container Project: Closed Container
von rcmodeler
1.2k
Downloads
998
Likes
3
Makes
Using https://www.thingiverse.com/thing:2536972 Corners,
we are now going to build a 20' closed container with doors on one shortside
which, of course, can be opened.
You can also have doors on both shortsides.
You always need the same amount of Corner and Corner_mirror, because the oval
hole in the corner should be longside in the upper and lower position of the container.
So if you are building a standard container you need to print four Corner_3 and
four Corner_3_mirror.
For one sidewall you need Longside_1 at both ends and Longside_2 in the middle.
For roof it is Roof_1 at both ends and Roof_2 in the middle.
Container_Door_Hinge_B fits with A if you don't use 3D-printed doors with hinges B.
You can of course use any material for wall/roof/doors.
Hinges might need some sanding to work smoothly.
Youtube link:
https://youtu.be/S83Cjz6E4JE
Alu-profiles length for standard 20':
H: 161mm
W: 152mm
L 20': 403mm
Parts needed:
Alu-profile 10x10x1mm
Sm
we are now going to build a 20' closed container with doors on one shortside
which, of course, can be opened.
You can also have doors on both shortsides.
You always need the same amount of Corner and Corner_mirror, because the oval
hole in the corner should be longside in the upper and lower position of the container.
So if you are building a standard container you need to print four Corner_3 and
four Corner_3_mirror.
For one sidewall you need Longside_1 at both ends and Longside_2 in the middle.
For roof it is Roof_1 at both ends and Roof_2 in the middle.
Container_Door_Hinge_B fits with A if you don't use 3D-printed doors with hinges B.
You can of course use any material for wall/roof/doors.
Hinges might need some sanding to work smoothly.
Youtube link:
https://youtu.be/S83Cjz6E4JE
Alu-profiles length for standard 20':
H: 161mm
W: 152mm
L 20': 403mm
Parts needed:
Alu-profile 10x10x1mm
Sm
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
