Basic Headphone Stand (RESIZE TO YOUR NEED)

Basic headphone stand that can hold literally any headphones. Its not a specific size so you can resize to your need. I used supports for my print because of the huge overhangs but I also found that the best settings are for it to be 228 mm in height (MAKE SURE TO SET UNIFORM SCALING). This is a big print but I think that it is completely worth it.

-Ultimaker Cura Settings-
1. (set uniform scaling) Z-Axis= 228mm
2. Supports=Yes (45 degrees)
3. Infill density= 20.0 with cubic infill)

TIME WITH ULTIMAKER CURA = 17 Hours 48 Minutes

Rough Cost of filament (155g)= $6.02