Thingiverse
Basic humanoid monster type with axe
por fred05072014
47
Descargas
35
Likes
1
Makes
Another attempt at this, a basic monster type orc or goblin with a simple axe.
Printed on my Printbot Simple using PLA, I have added support for the are which can be easily cut off after printing
The figure stands approximately 30 mm tall not including the height of the base.
The finish is not brilliant so if any one has any tips on how to improve the finish on PLA prints I would love to here them. Other wise I think I ill have to wait until I can print with ABS.
Printed on my Printbot Simple using PLA, I have added support for the are which can be easily cut off after printing
The figure stands approximately 30 mm tall not including the height of the base.
The finish is not brilliant so if any one has any tips on how to improve the finish on PLA prints I would love to here them. Other wise I think I ill have to wait until I can print with ABS.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
