Basic Laptop Notebook stand (30.55 mm)

v2: https://www.thingiverse.com/thing:4194963

This is a laptop stand that I made for a 30.55 mm thick laptop (the actual distance between the prongs are 31 mm. It's still a little messy, but I'm proud of it, because I made it from scratch!

I haven't printed it yet, but I plan to print it on a Makerbot replicator 3.

EDIT: Printed it on a lulzbot taz 5. It prints fine, but the supports are too short to adequately support the laptop. It may tip over! So don't print this unless you plan to make the prongs taller.