Thingiverse
Basic Mount for Arduino Mega
par beermeister
26
Téléchargements
11
Likes
0
Makes
Basic Mount for Arduino Mega (2560 Rev3).
Use M3 Spacers (+Screws +Nuts) to Mount µController (cheap Nylon sets are fine).
The Holes to screw the whole thing onto something are 4.5mm wide (and 8mm deep).
Some Cheap Arduinos don't have the two middle holes.
I took the hole distances from the official Eagle-File.
(The Shield on the last picture is a "GeeekPi MEGA 2560 R3 Terminal Block Breakout Board Hat")
Use M3 Spacers (+Screws +Nuts) to Mount µController (cheap Nylon sets are fine).
The Holes to screw the whole thing onto something are 4.5mm wide (and 8mm deep).
Some Cheap Arduinos don't have the two middle holes.
I took the hole distances from the official Eagle-File.
(The Shield on the last picture is a "GeeekPi MEGA 2560 R3 Terminal Block Breakout Board Hat")
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !