Basic Small Desktop Pliers Holder

Simple pliers holder that you use on a work desk/bench, uses two printable A frames at each end.

The acorn nut holder is printed a bit undersized and you press them in with pliers or with the threaded rod its self with the backing jam nut.

What you need to print:

~2x A frames

What you need to buy:

~1x 1/4x20 threaded rod ( can be any length you need mine was a pre cut 12" piece)
~2x 1/4 or M6 washers
~2x 1/4x20 acorn(cap) nut
~2x 1/4x20 regular nut

Optional heat shrink or electrical tape to wrap around the rod for a better look and less slipping.