Thingiverse
Basic USB Holder
von GoldenHolden
3
Downloads
2
Likes
0
Makes
This is a simple USB stick holder that was supposed to fit somewhere that it ultimately didn't but I liked the design enough to upload it here.
It's 13.41cm long and 8.3cm wide. Holes are 2.9cm long so a chunky Kingston USB stick can fit in there and the whole depth of the print is 3cm.
There is a design with and without the test and one with the most holes possible for the space used. (I don't Have a good looking image of the onshape file)
It's 13.41cm long and 8.3cm wide. Holes are 2.9cm long so a chunky Kingston USB stick can fit in there and the whole depth of the print is 3cm.
There is a design with and without the test and one with the most holes possible for the space used. (I don't Have a good looking image of the onshape file)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
