Basic Wedge Combat Robot (Plastic Antweight)

These are the files used for Blue Dream, a Plastic Antweight combat robot. This robot has performed fairly successfully, and is very easy to assemble and maintain.

Parts required to build:

- 1 Frame
- 1 Top Plate
- 2 Motor Mounts (Pick the one that fits your motors. The 16mm should fit the Fingertech 'Spark' motors as well as the Repeat Robotics 16mm motors. The 22mm should fit most 22mm gearmotors, but for sure fit the Just 'Cuz Robotics 'Gecko' motors)
- 1 Bolt
- 1 Nut
- 1 Wedge or 7 Forks, depending on the configuration you would like to use - Mix and match for extra effectiveness!

Non-Printed Parts:

- 1 Transmitter/Receiver
- 2 Drive Motors (I recommend either the Repeat Robotics 16mm motors or the Just 'Cuz Robotics 22mm motors)
- 2 Speed Controllers (or one dual-ESC)
- 1 Battery (The battery compartment fits the Galaxy 3S 300mah pack fairly snugly)
- 1 Power Switch (The frame is designed to fit the Fingertech 3.5mm Switch / Charge Jack that comes with the Vip