Thingiverse
Bass knob box
von Kickergod69
5
Downloads
3
Likes
0
Makes
Print the box face down open side up and it does not need supports. Print lid flat.
The lid snaps in very snug and may need to be sanded down a bit. There are no screw holes because I had intended on using super glue to seal it up.
The lid snaps in very snug and may need to be sanded down a bit. There are no screw holes because I had intended on using super glue to seal it up.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!