Bathroom corner shelf

Simple bathroom shelf with dimensions of 20x20cm with a rounded corner.Use it for storing light items; otherwise, the curved part might bend. UpdateI've uploaded a new version with a small lip added under the curved part, which should increase strength.Select “with lip” profile to print this version. I printed it on the default textured bed on P2S, prints in less than 3 hours with ~110g of filament. I used Sunlu PLA+ White; PETG might be a better choice if you need strength, although it might look more glossy. Mounting using 3M VHB tape (I used gph-110gf), no drilling required. There are slots for 1cm tape - mine was 14mm in width, so I had to cut it slightly. Boost MeThis is my first public model, any feedback or print photos will be appreciated :)Mounting:Clean surfaces with IPA or degreaser firstApply tape to both sides - one strip should be enough, I used two, so it should be permanent Make sure that the shelf is level to the ground first.Stick the shelf to the tiles and apply