Thingiverse
Bathroom drain cover
von jjbird
8
Downloads
3
Likes
0
Makes
I needed to replace the drain cover on my bathroom floor. I whipped out my calipers and made some measurements and then produced a parametric model in OpenSCAD.
Perfect fit first time!
Printed in PLA and it looks to be holding up fine so far after three months.
Perfect fit first time!
Printed in PLA and it looks to be holding up fine so far after three months.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!