MakerWorld
Other House Models
Ver Modelo
Bathroom/kitchen organizer
5
Descargas
2
Likes
0
Makes
Bathroom/kitchen organizer:- soap/sponge/rubber duck holder with drip chute- toothbrush/razor/brush/toothpaste holder- space for shampoo/dishwasher- …The prototype was printed in PLA: ~110g filament, ~4+h print time, minimal amount of support+ 4 TPU legs to prevent slip and give some clearance so water can drip out at the bottom+ a bottom tray if needed (this does not cover the soap holder's drip chute, that should stick out over the sink)For future easy clean I will print the final model in ABS and use acetone vapor smoothing.The soap tray is at 33°, consider printer capabilities if choosing not to add support - X1C can handle it without support.Dimension without tray: width: 174mm * depth 104mm base + ~23mm chute * height 102,2mm + 3mm legsTray: 186.5mm * 116.5mm
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!