Thingiverse
Bathroom Organizer
di Danjanes
11
Download
7
Likes
0
Makes
Custom bathroom organizer for my bathroom. Comes in two parts (or a single piece). One side took up pretty much the whole space for my Prusa i3 MK3S. The middle box can fit a square kleenex tissue box perfectly.
Designed in FreeCAD. Files (FCStd) included
**Print Speed/Settings:** PLA, .3mm, 20% infill, normal speed took ~20 hours for one side.
**Dimensions Once Printed:**
216mm Deep
381mm Wide
140mm Tall
**Suggested Assembly:**
Print both sides and use super/gorilla glue to glue the two pieces together. Wait a few hours to a day to dry, and you are good to go. The thicker the glue, the better; the width of the walls is not super wide, so runny glue could drip down the sides easily. I had minimal warping on the sides, and they were pretty close with next to zero gaps after gluing. Will come down to filament choice, print quality/resolution/speed/etc.
Designed in FreeCAD. Files (FCStd) included
**Print Speed/Settings:** PLA, .3mm, 20% infill, normal speed took ~20 hours for one side.
**Dimensions Once Printed:**
216mm Deep
381mm Wide
140mm Tall
**Suggested Assembly:**
Print both sides and use super/gorilla glue to glue the two pieces together. Wait a few hours to a day to dry, and you are good to go. The thicker the glue, the better; the width of the walls is not super wide, so runny glue could drip down the sides easily. I had minimal warping on the sides, and they were pretty close with next to zero gaps after gluing. Will come down to filament choice, print quality/resolution/speed/etc.
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
