Thingiverse
Bathroom Sink Strainer
por cornedbeef
5
Descargas
5
Likes
0
Makes
Bathroom sink plug hole filter to fit 38mm hole.
Can be printed without supports,
Loved the original design by X1Project. However, due to the way it sat on our sink, water flow was really slow.
Modifications done:
- Connected the two top most holes to increase water flow.
- Shortened the lower end to save on filament
WARNING: This remix was not test printed since the print of X1Project's design was physically modified. However, the modifications done (theoretically) should not impact the printing.
Can be printed without supports,
Loved the original design by X1Project. However, due to the way it sat on our sink, water flow was really slow.
Modifications done:
- Connected the two top most holes to increase water flow.
- Shortened the lower end to save on filament
WARNING: This remix was not test printed since the print of X1Project's design was physically modified. However, the modifications done (theoretically) should not impact the printing.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!