Battery Box Holder

Made this to fit three 3.7V 2000mAh batteries in parallel to hide my the looks of the battery and have just a positive and negative port. Now I have a 6000mAh 3.7V battery and it looks good. This is a custom design for a project I have been working on for a solar panel battery charger. Just figured I would post the box I designed to add to the huge online archive of designs that I know I use quite often. The box has a slide on lid that the lid clips into the back holes.

Used my Elegoo Neptune 3 Pro and sliced in Elegoo Cura.



Here are the notes I took when designing it:
64mm x 79mm outer box with the 2mm wall thickness
60mm x 75mm inner box
22mm on top of the 2mm flat piece on the bottom
LID 64mmx75mmx2mm
2mm holes for lid
15mm out from sides center of holes are 3mm down

Lid size 1.8mm x 61mm x 77mm