Battery Box Large Ver 3

Description*** UPDATEI wasnt happy with the original latch setup so I made some changes, switched to a clip type latch on ver 3 . I also included a retrofit file for those of you that had already printed the ver2 battery box. The retro fit is pretty easy, cut off the latch extension on the top, glue the retro latch top and bottom to the box make sure they butt up tight , add two m3x20 screws and the clip and its done. The version 3 box has the new latch integrated as part of the model. Liked the Battery box by hologos but it wasn’t big enough. I remixed it to twice the size and added a better front latch for the top and thickened the top near the CR2032 battery slots to keep them from falling out if the box was turned upside down. Can store 40 AA, 40 AAA, 4 - 9 volts and 8 CR2032 batteries. Print SettingsMaterial: PLA or PLA+Layer height: 0.2 mmPerimeters: 3 (you can use 2 but the sides flex a little when you push)Top layers: 4 layersInfill: 15% lightning Supports: no batterybattery bo