Thingiverse
Battery Case Phone Stand
door TheViralDIY
2
Downloads
1
Likes
0
Makes
Wanted a phone stand that could fit extra thick phones with battery cases. Version 3.0 and 3.0s are the recommended models
Modeled to fit phones about 0.75" or 20mm thick
Model is 76.2mm wide
Version 1.0: Basic stand with 45 degree triangles cut out
Version 1.1: Basic stand reinforced, 45 degree triangles cut out
Version 2.0: Additional triangles cut out, not printed
Version 3.0: Hexagon cutouts to save material
Version 3.0s: Smaller hexagon version (~50%, 38.7mm wide)
Modeled to fit phones about 0.75" or 20mm thick
Model is 76.2mm wide
Version 1.0: Basic stand with 45 degree triangles cut out
Version 1.1: Basic stand reinforced, 45 degree triangles cut out
Version 2.0: Additional triangles cut out, not printed
Version 3.0: Hexagon cutouts to save material
Version 3.0s: Smaller hexagon version (~50%, 38.7mm wide)
TheViralDIY publiceert ook op
20 extra modellen op 2 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
