Tools
Zum Modell
Battery Holder for Multiboard
106
Downloads
22
Likes
0
Makes
Only requires 1g of support Around 45g of filament (with support) Infill: 15% Wall loops: 3 Print at a 30-degree angle, as shown on the attached screenshot Manually draw normal support, as shown on the attached screenshot Use "13 mm Small Thread, Flat Head, Shank T-Bolt" if your Multiboard is mounted with 8mm offset or "9 mm Small Thread, Flat Head, Shank T-Bolt" if it's mounted flat. The model includes offsets that allow you to mount it over mounting snaps (see photos)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!