Battery Mockups

This is an AA battery mockup designed to replace AA batteries with an external
power source. You will need 2 one-sided PCB pieces. One with a 5 mm diameter
and another one with a 9 mm diameter. You will need to print 2 body and attach
one PCB piece at the end of each one. The 5 mm PCB piece will act as the
negative pole, while the 9 mm one as the positive pole. Some glue is needed to
attach the PCB pieces to the end of the battery mockups. You will also need a
soldering iron. You will need to solder a wire to each PCB piece.

Support material is not required. An infill of 20% is recommended.

This object main web page is:
http://www.ctheroux.com/battery-mockups/.

This object was designed using Solid Edge Community Edition.

You can request the source files on the page listed above.