Thingiverse
Battery powered IR Head Tracker
por GoodestGoyim
4
Descargas
4
Likes
0
Makes
AA Battery powered version of a Track IR Clip.
The switch is superglued to the frame.
Materials required:
-Wire
-switch (clip off one of the contacts on the side)
-30 Ohm resistor (yours depends the voltage of your LEDs. check out an online resistor
calculator for parallel circuit LEDs)
-IR LEDs of your choice. (mine are 1,5V 20mA)
The switch is superglued to the frame.
Materials required:
-Wire
-switch (clip off one of the contacts on the side)
-30 Ohm resistor (yours depends the voltage of your LEDs. check out an online resistor
calculator for parallel circuit LEDs)
-IR LEDs of your choice. (mine are 1,5V 20mA)
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
