Thingiverse
Baufix Rods
von CaCO3
0
Downloads
1
Likes
0
Makes
Baufix Rods with the correct 3.6mm pitch height.
I made a small one 7.5mm (2 Taps + 0.3 mm extra), then joined them together (with 0.3mm overlap) for longer rods.
The sizes match more or less the wooden rods I have.
Make sure to lay them flat on one of the two trimmed longer sides for best stability.
I used 100% Infill for max stability, but it will also work with less infill.
I made a small one 7.5mm (2 Taps + 0.3 mm extra), then joined them together (with 0.3mm overlap) for longer rods.
The sizes match more or less the wooden rods I have.
Make sure to lay them flat on one of the two trimmed longer sides for best stability.
I used 100% Infill for max stability, but it will also work with less infill.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!