Thingiverse
BCAR for FDL-3
door LeeOh
9
Downloads
7
Likes
0
Makes
Angle: 8 degrees (optimized for FLD-3 standard build)
Recommended FPS range: 130 - 200 FPS
Required:
12 x MF84ZZ 4x8x3mm Flanged Bearings
12 x M4x10mm Screws
12 x M4 Washers
Compatibility: Work with both half and full length darts.
Note: Extender is required when using full length darts. Use washers between the bearing and the 3D-printed part to minimize friction. Accuracy gain depends on your choice of dart and print quality.
Recommended FPS range: 130 - 200 FPS
Required:
12 x MF84ZZ 4x8x3mm Flanged Bearings
12 x M4x10mm Screws
12 x M4 Washers
Compatibility: Work with both half and full length darts.
Note: Extender is required when using full length darts. Use washers between the bearing and the 3D-printed part to minimize friction. Accuracy gain depends on your choice of dart and print quality.
LeeOh publiceert ook op
1 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
