Thingiverse
Beam Clamp
door hletchworth
9
Downloads
3
Likes
0
Makes
Clamp for any type of overhang to help with cable management. There are two verisons, one for a small zip tie and one to allow 4 CAT-5 cables to pass through.
The opening is 0.5" tall and just a bit over 0.7" deep. The hole and nut are modeled for a 1/4" bolt and nut, 1" length will allow for the full bite.
Scaling is possible but you will have to keep an eye on your bolt and nut hole dimension.
The opening is 0.5" tall and just a bit over 0.7" deep. The hole and nut are modeled for a 1/4" bolt and nut, 1" length will allow for the full bite.
Scaling is possible but you will have to keep an eye on your bolt and nut hole dimension.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!