Thingiverse
Beared Filament Wall Holder
por T4m4go
1
Descargas
0
Likes
0
Makes
This is an beared Filament wall holder.
You will need 95mm of M8 threaded rod and two bearings (inner width: 8mm, outer width: 22mm).
The nut will be needed 4 times.
Printed with PETG (will also work with PLA) and 0.10mm layer height.
You will need 95mm of M8 threaded rod and two bearings (inner width: 8mm, outer width: 22mm).
The nut will be needed 4 times.
Printed with PETG (will also work with PLA) and 0.10mm layer height.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
