Thingiverse
Bearing Car
von CubeCraftGalaxy
0
Downloads
0
Likes
0
Makes
This is for a 8x22x7 bearing (aka the standard ball bearing (the same one in most fidget spinners)) Your printer must be good in bridging if you want to print without supports. I made it a little bigger than it should be so you can print without supports. If you print it make sure you tell me what you used and what happened.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
