Bearing spool holder

Model with connectors was designed for spool: 200x64mm if you have a wider spool dont't print connectors.

To assemble you need:
+ 2x External-Part.stl
+ 2x External-Connecting-Part.stl
+ 4x Bearing 608

Optional:
+ 4x Centering-Ring.stl (recommended)
+ 2x Connector.stl (for spool: 200x64mm)

After all parts are printed:
1. If you have printed the centering rings, install them on the bearings
2. Place the bearings on the protruding pin from the outer connecting part
3. Connect the outer part tightly with the outer connecting part to form a rail
4. If you have printed the connectors, connect 2 rails

If you have problem, questions, feedback write in comments, i will try to answer as quickly as i can.
Hope you like this model!