Thingiverse
bearings
door sciencetech3d
0
Downloads
2
Likes
0
Makes
Two-part bearings - one inner ring and one outer ring, internally with V-shaped grooves between the rings and a small gap(0.3mm) between the groove faces.
One 5mm ID x 11mm OD x 5mm H
One 7mm ID x 14mm OD x 7mm H
One 10mm ID x 22mm OD x 16mm H
Some effort may be required to loosen the parts.
- may try using a nail puncher to knock on the bearing face
- may try using tighten two nuts on the bearing faces and turning it loose.
One 5mm ID x 11mm OD x 5mm H
One 7mm ID x 14mm OD x 7mm H
One 10mm ID x 22mm OD x 16mm H
Some effort may be required to loosen the parts.
- may try using a nail puncher to knock on the bearing face
- may try using tighten two nuts on the bearing faces and turning it loose.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!