Thingiverse
Bed Center Test
von Whospatlaw
12
Downloads
9
Likes
0
Makes
This is a print to help find the how close your printer is to the center of the print bed so you can adjust an offset in the slicer accordingly.
I just upgraded my Chiron to direct drive which pushed the head out in x further, so after performing this print and using some calipers, I could input an offset of -24mm in x and 5.5mm in y to get exactly centered.
I just upgraded my Chiron to direct drive which pushed the head out in x further, so after performing this print and using some calipers, I could input an offset of -24mm in x and 5.5mm in y to get exactly centered.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
