Thingiverse
Bed Centering Print
von KevPV
36
Downloads
10
Likes
0
Makes
This is a very simple crosshair for you to calibrate your printer's bed center.
Mark the center of your bed with masking tape or something and then print this centered in your software. Then, measure the distance in X and Y from the print to the actual center and make adjustments in your firmware as needed. It may take a few tries, but it will get your prints centered perfectly really easily.
Mark the center of your bed with masking tape or something and then print this centered in your software. Then, measure the distance in X and Y from the print to the actual center and make adjustments in your firmware as needed. It may take a few tries, but it will get your prints centered perfectly really easily.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!