Thingiverse
Bed Clamp
von BrainDamage193
37
Downloads
20
Likes
0
Makes
This is my design for 3D Printer Bed Clamp. After installing my ultrabase on my Ender 3 my original paper clip didn't fit and I had nothing else.
Your gonna need:
1x M6 Nut
1x M6 Bolt (Longer depend on you I use 25mm)
I print it in PETG.
Your gonna need:
1x M6 Nut
1x M6 Bolt (Longer depend on you I use 25mm)
I print it in PETG.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
