Slicer Discord
Bed Rail Base Cover – 3D-printbaar model van MakerWorld MakerWorld
3D Printer Parts

Bed Rail Base Cover

688 Downloads
145 Likes
421 Makes
Model downloaden
Plug/Cover to block debris from getting inside the hole at the bottom of the rail for the bed. Was just looking to grab a hair more clearance so I trimmed 1.25mm off the top of the model to make it slightly thinner (2mm vs 0.75mm, you can see the difference in the second picture). Credit to clselee.tw for the great model! *Note: When the bed is fully in the bottom position the bearings on the rails slide in to these holes, so just make mental note to remove them if you plan to print with the full range of the Z axis Boost MeFound it helpful? Send me a boost, thank you! Looking for more covers to clean things up, check out some of my others!
Categorie
3D Printer Parts
Bron
MakerWorld
Gepubliceerd
Bijgewerkt
Wat je nodig hebt om te printen: Gemiddeld Lage betrouwbaarheid
Eendelig Hardware nodig
Supports 1/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 1/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
PLA
Nabewerking
Hardware
Software
Cura, PrusaSlicer of vergelijkbaar
Nog geen beoordelingen
Nog geen reacties – wees de eerste!

Vergelijkbare modellen

6 Suggesties
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie