Thingiverse
Bed Scraper + Leverage
von oic165
111
Downloads
68
Likes
0
Makes
A simple bed scraper, I needed something that gave me a bit of leverage and wouldn't snap on me, or scratch my print beds.
Bit of sanding to remove where the supports were, and this thing should be good to go for a long while. I printed this on my Ender 3, sideways so the layers run lengthwise to optimize strength
Good luck, drop a line somewhere if you have any issues, I'll address them as best as I can.
Bit of sanding to remove where the supports were, and this thing should be good to go for a long while. I printed this on my Ender 3, sideways so the layers run lengthwise to optimize strength
Good luck, drop a line somewhere if you have any issues, I'll address them as best as I can.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
