Slicer Discord
Bedside Accessory System - Bottle holder – 3D-Druckmodell von MakerWorld MakerWorld
Other House Models

Bedside Accessory System - Bottle holder

114 Downloads
27 Likes
89 Makes
Zum Modell
I am happy to release a bottle holderfor my Bedside Accessory System. All of the accessories in the Bedside Accessory System are mounted to a hook that slides over the frame of your bed. The biggest benefit of this system is its modularity, allowing a common interface to make customization to your use case a lot easier. I created the system when my bedside table ran out of room, and my cats liked to knock stuff over. I've released two sizes for the bottle holder. The smaller one is sized for my favorite LTT 21oz water bottle, the holder itself has an opening of 3 inches or 76mm and it's 50mm deep, and the larger one is sized for bigger waterbottles like the LTT 40 oz, but it will also fit other popular big water bottles, like Stanley etc. I've added multiple hook sizes, so there are 18, 20, 22, 25, and 40mm sizes. This should cover most steel and wooden bed frames. I noticed the taller bottles have a tendancy to pivot on the hook so I created a Wide version of the hook. Let
Kategorie
Other House Models
Quelle
MakerWorld
Veröffentlicht
Aktualisiert
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Wood PLA
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen