Thingiverse
Bedside Remote Controls Hanger
von OfirYaron
12
Downloads
4
Likes
0
Makes
This design was created from scratch to match my bedside table shelf (18cm)
In addition I've designed a small optional headset hook that hang on the remote-controls 'pocket'
The headset hanger is better printed on the side
The remote controls hanger could be printed in two ways:
- on the side - only if you know how to make your printer print a >50% angle and >15mm bridges.
- (Otherwise) Using support and printing it up-side-down.
In addition I've designed a small optional headset hook that hang on the remote-controls 'pocket'
The headset hanger is better printed on the side
The remote controls hanger could be printed in two ways:
- on the side - only if you know how to make your printer print a >50% angle and >15mm bridges.
- (Otherwise) Using support and printing it up-side-down.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
