Bedstand Watch

Bedstand watch based on TTgo-Board connected to Homeassistant using ESPHome.
Main advantage is, that the watch turns the display off automatically. Activation is done by touch sensor. Brightness is managed using a photo resistor (the darker the room, the less bright is the display).
On top of the display, the time of the wakup light is shown (established in HA).
Currently there is no functionality for the buttons, but feel free to add additional pages to the config.

Micro USB-plug is used, because I wanted the power source to be on the backside of the case.

All components fixed inside the case using hot glue (be careful because of the heat).
Inside the case I also placed two 6mm nuts just to give it a better stand.

Backside of the Solderings at the PCBs needs to be cut flat so that the PCBs are fittung in the case.

Used parts (NO affiliate links):
TTgo: https://www.amazon.de/dp/B07XHH3YRZ
Touch: https://www.amazon.de/dp/B07Z4GF6GG
Photo resistor: https://www.amazon.d