Thingiverse
Bee Hive Stopper
door crua9
58
Downloads
28
Likes
0
Makes
Basically, this is a part I made for someone that wanted to stop their bees from going out at given times.
BTW if your filament is about $25 and you do the 5% infill as I suggested. This will cost close to $1 per stick.
BTW if your filament is about $25 and you do the 5% infill as I suggested. This will cost close to $1 per stick.
crua9 publiceert ook op
68 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!