Thingiverse
BeeseChurger Necklace
door cconnrradd
2
Downloads
3
Likes
0
Makes
For all those looking to spice up the Kentucky VEX tipping point tournament. BeeseChurgers for life! Compliments of HouseCats 9257C
Place game piece in center ring and use VEX Chain attached to the two outside rings to form a spiffy necklace to wear at the comp.
STL file and Simplified3d file provided.
Print using PLA with supports.
Make sure to use the updated file if you can that has a 3 in the STL filename. The back hole for the ring was increased to allow the ring to slide in easy. If you use the original file, it will still print, but you will most likely end up having to either use a Dremel to make the slot bigger or end up gluing it back together when it snaps. I glued mine :) a little epoxy and a screw holds the ring nicely.
Place game piece in center ring and use VEX Chain attached to the two outside rings to form a spiffy necklace to wear at the comp.
STL file and Simplified3d file provided.
Print using PLA with supports.
Make sure to use the updated file if you can that has a 3 in the STL filename. The back hole for the ring was increased to allow the ring to slide in easy. If you use the original file, it will still print, but you will most likely end up having to either use a Dremel to make the slot bigger or end up gluing it back together when it snaps. I glued mine :) a little epoxy and a screw holds the ring nicely.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!