Thingiverse
Beetle stop entrance
door BlueSkys12
19
Downloads
8
Likes
0
Makes
A new concept to stop Hive beetles entering hives with a 45 degree pipe.
This is a two piece approach and I can make this into a three piece approach by using a PCV cap and cutting it in half. All items are available at the hardware store.
I can make this as a bolt on but I assume you will push a tiny section of 1 inch pipe into the hole you cut in the hive and then attached the main part.
Part B slips over Part A.
I was not able to catch a swarm and try this. Please comment if it works the same as the retail versions. Instead of aiming down, I can add a cover so you can turn it horizontal sideways. so rain will not go into the entrance.
This is a two piece approach and I can make this into a three piece approach by using a PCV cap and cutting it in half. All items are available at the hardware store.
I can make this as a bolt on but I assume you will push a tiny section of 1 inch pipe into the hole you cut in the hive and then attached the main part.
Part B slips over Part A.
I was not able to catch a swarm and try this. Please comment if it works the same as the retail versions. Instead of aiming down, I can add a cover so you can turn it horizontal sideways. so rain will not go into the entrance.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
