Thingiverse
BeLeaf Vape Battery Holder
von eddiewebbinaro
4
Downloads
3
Likes
0
Makes
Super simple little stand to hold beleaf sherlock style vape cartridge battery holder
The smaller one does stay upright by using the battery's own weight to push up the cartridge a bit.
The full one with extra leg may be needed for 1g or heavy cartridges (i havent..)
20% infill
.2 mm layer
200 C for PLA
### Files:
- Small stand base sits flat, cartridge at angle of 20° or so.
- Large stand, base sits flat, cartridge at 20° or so.
- Angled stand, cartridge sits at ~50°. (good for getting every last drop)
The angled stand includes instructions/reminders for 2,3,5 click operation of battery.
The smaller one does stay upright by using the battery's own weight to push up the cartridge a bit.
The full one with extra leg may be needed for 1g or heavy cartridges (i havent..)
20% infill
.2 mm layer
200 C for PLA
### Files:
- Small stand base sits flat, cartridge at angle of 20° or so.
- Large stand, base sits flat, cartridge at 20° or so.
- Angled stand, cartridge sits at ~50°. (good for getting every last drop)
The angled stand includes instructions/reminders for 2,3,5 click operation of battery.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
