Thingiverse
Bell striker - bicycle replacement
door hOZ
0
Downloads
0
Likes
0
Makes
This is a replacement bell striker, intended for use with a bicycle bell with a broken thumb striker.
It can be printed quickly (less than 30 minutes) and easily, only a small section of support is required. I believe it is around 2g of material. It can be adhered onto the bell with glue, I used a 5-minute epoxy.
I hope this is a common bell type, let me know if it does or doesn't work for you. I think some fine tuning of the striker position could be done to improve the ring.
It can be printed quickly (less than 30 minutes) and easily, only a small section of support is required. I believe it is around 2g of material. It can be adhered onto the bell with glue, I used a 5-minute epoxy.
I hope this is a common bell type, let me know if it does or doesn't work for you. I think some fine tuning of the striker position could be done to improve the ring.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
