Thingiverse
Belt guide for PrinterMods.com direct drive kit
di NDCSR
3
Download
0
Likes
0
Makes
I had a belt snap on the sharp edge of the PrinterMods.com direct drive kit E plate.
rather than file the edge I printed this up and installed 2 on the belt forks.
it's a little tight but it goes on and stays there.
rather than file the edge I printed this up and installed 2 on the belt forks.
it's a little tight but it goes on and stays there.
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!