Thingiverse
Belt Hanger
von danielzn
28
Downloads
36
Likes
0
Makes
A hangar to store up to 10 belts. It can be printed without the plug piece, since the friction between the hanger piece and rack piece is quite strong.
Print the hangar and rack as flat as possible to maximize strength. I would suggest using a raft, and supports for >30 degrees for the hangar piece, however the rack doesn't require supports or adhesion.
Other than that, any print settings should work.
Print the hangar and rack as flat as possible to maximize strength. I would suggest using a raft, and supports for >30 degrees for the hangar piece, however the rack doesn't require supports or adhesion.
Other than that, any print settings should work.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!